Deep Foundations

H-Pile Splice Attachments

procedure-lrg

Need better description. Sed ut perspiciatis unde omnis iste natus error sit voluptatem accusantium doloremque laudantium, totam rem aperiam, eaque ipsa quae ab illo inventore veritatis et quasi architecto beatae vitae dicta sunt explicabo. Nemo enim ipsam voluptatem quia voluptas sit aspernatur aut odit aut fugit, sed quia consequuntur magni dolores eos qui ratione voluptatem sequi nesciunt.

  • Scarf the outside edges of flanges of H to be added.  Torch cut a 7/8 in. x 2 1/8 in. notch for spacer bar in either driven or added length.
  • Slip splicer on pile (tap with sledge if needed).  Make 5/16 x 2 1/2 in. fillet weld of splicer to flange at each corner.
  • Set length to be added on driven H.
  • Make 5/16 in. (or heavier) groove weld full width of each flange and at each remaining corner.